Deltech-fitness DF805- Seated Calf Machine User Manual

ASSEMBLY INSTRUCTIONS FORTHE DF805 SEATED CALF700 LB WEIGHT CAPACITY WEIGHT AND USER*NOTE IF YOU ARE MISSING HARDWARE OR HAVE ANY FIT UP PROBLEMS PLEA

INSTRUCTIONS FOR USELOAD THE DESIRED AMOUNT OF WEIGHT PLATES ONTO WEIGHT COLUMN. SECUREWEIGHTS WITH SPRING COLLAR.LOOSEN PULL-PIN AND ADJUST KNEE PADS

WARNING: THE USER OF THIS WEIGHT EQUIPMENT ASSUMES THE POSSIBILITY OF INJURY BYEXERCISING ON THIS EQUIPMENT. THE RISK OF INJURY CAN BE REDUCED BY ALWA

SEND TO: DELTECH MANUFACTURING, INC.3910 OAKLAWN DR.LOUISVILLE, KY. 40219ALL ORDERS SHIPPED UPS GROUND.MAKE CHECK OR MONEY ORDER PAYABLE TO: DELTECH M

DF805BOX CONTENTSDF805INSTRUCTIONSQTY 1*NOTE IF YOU ARE MISSING HARDWARE OR HAVE ANY FIT UP PROBLEMS PLEASE CONTACT DELTECH FITNESS TOLL FREE (888) 25

DF805HARDWARE*NOTE IF YOU ARE MISSING HARDWARE OR HAVE ANY FIT UP PROBLEMS PLEASE CONTACT DELTECH FITNESS TOLL FREE (888) 258-0533RUBBER SHOEQTY 4IHAN

TOOLS REQUIRED:WRENCHES OR METRIC SOCKET SETASSEMBLE THE KNEE PADS (F) TO THE LEG PAD FRAME (A) USING THE M10 x 65MM BOLTS(O), AND M10 WASHERS (S). IN

INSTALL THE RUBBER SHOES (I) AND RECTANGULAR CAPS (L) INTO THE BASE FRAME (C).BOTTOM FRAME ASSEMBLYIIIILLCW

PUSH THE HAND GRIP ONTO THE UPPER FRAME SUPPORT ARM (I).ASSEMBLE THE UPPER FRAME SUPPORT ARM (D) TO THE BASE FRAME USING THE M12 x90MM BOLT (N), M12 W

INSTALL THE SQUARE CAP (K) INTO THE BOTTOM OF THE ADJUSTMENT TUBE (H).NEXT INSTALL THE ADUSTMENT TUBE (H) TO THE WEIGHT FRAME (B) USING THE M12 x90MM

INSTALL THE LEG PAD FRAME ASSEMBLY INTO THE ADJUSTMENT TUBE.INSTALL THE SEAT (E) ONTO THE WEIGHT FRAME WITH THE M10 x 90MM BOLTS (P), ANDM10 WASHERS (

ASSEMBLE THE WEIGHT FRAME ASSEMBLY TO THE LOWER FRAME ASSEMBLY USING THEM12 x 90MM BOLTS (N), M12 WASHERS (R), AND M12 WASHERS (T).MAKE SURE ALL THE B